ID - OD Table

The ID - OD Table is a measuring unit known for its rapidity, easiness, reliability are the characteristics to check internal or external dimensions previously set by known standard.  The dimension is obtained by reading the maximum point during the travel of the part between a fixed and moving anvil. The measuring station is designed for maximum versatility and the measurements of parts where inspection accuracies and tolerances are critical. With the easily adjustable measuring force by the operator, this gage is suitable for inspecting thin wall parts or less rigid plastic parts.

Technical data:

Accuracy: +/- 0.000040"/ +/- 0.001mm

Repeatability: < 0.000040"/< 0.001mm

Robustness: use on Shop floor

Wide measuring range from the smallest possible measured dimensions:

Inside diameter .079"/2mm to 7.480"/190mm and outside diameter .000"/0mm to 6.300"/160mm

High versatility

Simple, fast fitting

Immediate internal-external conversion

Adjustable measuring force (low measuring force for thinwall parts) 

Possibility of direct dimension readout, by electronic preselecting display device

Choose your readout with mechanical, electronic indicator or transducer with comparator

Possibility of integration in a flexible machining system, for automatic inspection with simultaneous correction of machine setting.